Power Quality Improvement Using DSTATCOM For IEEE 9 Bus System

Komal Mehra; Gursewak Singh Brar; Ranvir Kaur

doi:10.55524/ijircst.2022.10.5.16

Abstract

The rapid rise of people is causing significant issues in the electricity system by increasing energy consumption or load demand. In Power System, there are several problems cause of overloading issues, dangerous blackouts, voltage fluctuations, and collapse. A system's voltage profile will be better as a result of improved reactive power compensation, raising the system's overall power quality. In this paper, the power quality analysis examined case study i.e. Standard IEEE 9 bus system describes the During-fault, and Post-fault conditions using DSTATCOM device carried out with MATLAB software. The pre-fault condition is accomplished using the power flow study by the Newton-Raphson method, and the influence of a three-phase balanced fault has been deliberated during-fault conditions. The IEEE-9 bus system was first examined using standard test data, and subsequently the same system was examined using D-STATCOM. The system's reactive power compensation, voltage profile, and line losses with and without D-STATCOM are all investigated.Also this paper presents a comparative analysis of IEEE 9 bus system power quality analysis using D-STATCOM device with respect to without DSTATCOM device to improve system performance.

Keywords

FACTS device, D-STATCOM, Transient Stability, and IEEE 9 Bus System

References

VinayM.Awasth, Vijaya Huchche“Reactive power compensation using D-STATCOM” International Conference on Energy Efficient Technologies for Sustainability (ICEETS) April 2022.
V Kumar, Khammampati R Sreejyothi, “A Review on D-STATCOM Control Techniques for Power Quality Improvement in Distribution”, Publisher: IEEE, 2021.
C.KrishnaKumar,Dr.K.JithendraGowd,”Compensation Of Linear/Non-Linear Loads By Implementation Of Adaptive Filter In Dstatcom”,IRJETS. November-2021
BhagyashreeParija,SantiBehera,RuturajPattanayak, SasmitaBehera, “Power Quality Improvement in Hybrid Power System using D-STATCOM”, International Conference on Computing Methodologies and Communication,IEEE, August 2019.
SupriyaSunilKadamand YuvrajKrishnaraoKanse, “DSTATCOM for Power Quality Improvement”, International Conference on Circuits and Systems in Digital Enterprise Technology IEEE Dec. 2018.
G.Arthy ; C. N. Marimuthu, “A survey on control algorithms for DSTATCOM”,IEEE, pp 1-4, 2017.
R.Ragesh; A.Bharaneetharan; R Vengadesh, “Design and control of SVPWM based DSTATCOM for power quality Improvement”, IEEE, pp 1-6, 2017.
P.M. Anderson and A.A Fouad, “Power system Control and Stability”, Iowa State University Press.
ANDREA ANGEL ZEA, “Power System Stabilizers for The Synchronous Generator Tuning and Performance Evaluation” CHALMERS UNIVERSITY OF TECHNOLOGY Goteborg, Sweden 2013.
SreevidyaT.R ,Dawnee S “Optimal Interaction of PSS and SSSC in a Power System Network” International Conference on Emerging Trends in Science, Engineering and Technology IEEE 2012

Cites this article as

K. Mehra, G. S. Brar, R. Kaur, "Power Quality Improvement Using DSTATCOM For IEEE 9 Bus System", International Journal of Innovative Research in Computer Science and Technology (IJIRCST), vol. 10, no. 5, pp. 113-118, 2022. doi: https://doi.org/10.55524/ijircst.2022.10.5.16

Corresponding Author

Komal Mehra

M. Tech Scholar, Department of Electrical Engineering, Baba Banda Singh Bahadur Engineering College, Fatehgarh Sahib, Punjab, India

Download Full Paper

Download PDF

No. of Downloads: 91 | No. of Views: 2117

Power Quality Improvement Using DSTATCOM For IEEE 9 Bus System

Citations

Total View 2117

Total Download 91